find /boot/grub/menu.lst error 15 file not found Maple Heights Ohio

Address 561 Boston Mills Rd Ste 100, Hudson, OH 44236
Phone (330) 656-1222
Website Link http://www.ltechsolutions.com
Hours

find /boot/grub/menu.lst error 15 file not found Maple Heights, Ohio

I transferred everything out of /boot into another folder /lfs, and had more success....at least it found the file. Solution Turn off framebuffer (typically remove vga=XYZ from grub.conf) and check the processor architecture in the kernel config. I copied the entries for the main xbuntu kernel etc and pasted them into my OEL grub.conf. yes Quote: The boot directory you are using is the same used for booting other linux distro?

What sense of "hack" is involved in five hacks for using coffee filters? Went into grub hitting c key at grub menu. Then ones I hardly remember like SCO Unix , then HP-UX, Solaris, AIX, OS X, HP Compaq Tru, and a few Linux variants and this had me confused. Bookmark Email Document Printer Friendly Favorite Rating: GRUB Error 15: File not found after applying kernel patchThis document (3939750) is provided subject to the disclaimer at the end of this document.

jpeters View Public Profile View LQ Blog View Review Entries View HCL Entries Find More Posts by jpeters 04-17-2009, 02:57 AM #4 kandiru Member Registered: Mar 2009 Location: Genoa, Have a Dell Inspiron 4100 laptop. 1GB RAM and 1 Ghz processor. When installing I choose to use the old version of GRUB and not GRUB 2 when given the choice to do so. Below was my experience, followed by some suggestions based on the hard lessons I learned.I rebooted the system.

Worked just fine, no issues that I could note. Is there a way using grub to get some more diag information? Only problem, the system still wouldn't boot normally. Hmm.

Page 1 of 2 12 Last Jump to page: Results 1 to 10 of 14 Thread: Grub Error 15: File not found Thread Tools Show Printable Version Subscribe to this Thread… title Ubuntu 10.10, kernel 2.6.35-22-generic uuid d6ed555c-54a3-4639-af25-3582c60624ad kernel /boot/vmlinuz-2.6.35-22-generic root=UUID=d6ed555c-54a3-4639-af25-3582c60624ad ro quiet splash initrd /boot/initrd.img-2.6.35-22-generic quiet Rebooted to test this appeared which it did and then selected the Ubuntu entry. Without them, all seems well. penetrode wrote that this may also be due to bad CFLAGS settings.

Newbies Corner Grub Error 15 (SOLVED) If this is your first visit, be sure to check out the FAQ by clicking the link above. Posted by Peter Leung at 5:34 PM Email ThisBlogThis!Share to TwitterShare to FacebookShare to Pinterest 2 comments: Anonymous said... Make sure if you have more than one Linux drive connected to your system that you have selected the correct one for booting. The Gentoo Name and Logo Usage Guidelines apply.

Still no joy! The upgrade involved quite a number of packages, including the kernel image.GRUB, the default boot loader, came to an abrupt stop with the error messageError 15: File Not found.The culprit was Minor versions can be omitted. ## e.g. The key was in the last step of installing Ubuntu, step 6 of 6, Click on the Advanced..

Also, when trying to boot Windows, make sure that the grub.conf file has the root (hdX,Y) (or rootnoverify (hdX,Y) ) and chainloader (hdX,Y)+1 in it. How was created the boot directory you want to use? Not fixed. kandiru View Public Profile View LQ Blog View Review Entries View HCL Entries Find More Posts by kandiru 04-19-2009, 05:24 PM #15 jpeters Member Registered: Mar 2009 Posts: 30

Provide Feedback © Micro Focus Careers Legal close Feedback Print Full Simple Request a Call Follow Us Facebook YouTube Twitter LinkedIn Newsletter Subscription RSS
Register If you'd like to contribute content, let us know. when you said create a device.map file with(hd0) /dev/sdaand place it in the grub folderDoes the mean type grub and then enter "(hd0) /dev/sda" and what if i just did There are lots of partitions on sdb but just the basic three (boot, swap, balance) on sda.

The contents of this document, unless otherwise expressly stated, are licensed under the CC-BY-SA-3.0 license. Like this:Like Loading... Old grub installs to a partition easily and can also be chainbooted if necessary. I can check by opening the box and disconnecting the first HD, and trying to get it to boot off the MBR on the second HD, or, wait, I can swap

GRUB error 15 Situation This error can occur in two different stages of the GRUB configuration, either during the initial configuration (installing GRUB in the master boot record) or after booting One possible cause is that ACPI is not working correctly but is enabled in the kernel. Thanks for the info.Rockwolf October 3, 2008 at 2:13 PM Anonymous said... Appreciate any help or suggestions.

title Ubuntu 10.10, kernel 2.6.35-22-generic root (hd0,0) # uuid d6ed555c-54a3-4639-af25-3582c60624ad kernel /boot/vmlinuz-2.6.35-22-generic root=UUID=d6ed555c-54a3-4639-af25-3582c60624ad ro quiet splash initrd /boot/initrd.img-2.6.35-22-generic quiet Still no luck so tried pointing the kernel line to /dev/hda3 which What is your running distro in your machine? It seems as if grub couldn't find there the right files (I mean stage1, stage2, and *stage1_5) Here Quote: http://www.gnu.org/software/grub/manual/grub.html in section 3.2 you can find some hints about what I Be careful not to change # the ‘exec tail' line above. ### END /etc/grub.d/40_custom ### =============================== sda5/etc/fstab: =============================== # /etc/fstab: static file system information. # # Use ‘blkid -o value -s

The following is incorrect, you need to define a partition to boot from (using root parameters). In our example here /dev/hda5            1276        1397      979902   82  Linux swap / Solaris /dev/hda6            1398        2550     9261441   83  Linux Swap :: /dev/hda5 and Linux root :: /dev/hda6 /dev/hda6 is your root Make sure that the file it is referring to exists on your boot partition. due to an incorrect drive and partition setting in the root line), the "boot installed system" procedure described above can be used again to fix things.PreventionThe boot failure can be prevented

Fill in your details below or click an icon to log in: Email (required) (Address never made public) Name (required) Website You are commenting using your WordPress.com account. (LogOut/Change) You are I have not had many problems booting and never done dual as nearly always dedicated servers. It also gives the UUID which I have verified is correct: sudo blkid /dev/sda1: LABEL="boot" UUID="b891774a-0b2d-4ab4-bcfa-23a11a97cae5" TYPE="ext2" /dev/sda2: UUID="fc34999a-e85d-4c7b-8775-30510eb4c396" TYPE="swap" /dev/sda3: LABEL="main" UUID="65a90a0d-a651-4215-8552-0c1859ab61dd" TYPE="ext4" The menu.lst (on /dev/sdb) for the new If your creating an LVM, install LVM after the initial install apt-get dist-update.