ford p1131 error code Port Ewen New York

Address 62 Vineyard Ave, Highland, NY 12528
Phone (845) 834-2351
Website Link http://acsguys.com
Hours

ford p1131 error code Port Ewen, New York

That will rule out a vacuum leak.. Can a clogged catalytic converter cause this??? Got a code on bank one sensor 2. Question - I have a Ford Taurus and want to change the Oxygen sensor that is located in the exhaust manifold on the windshield side.

Luckly, the PCM is covered under Ford emission system warranty. 8/80, so no charge to fix it. Tools Hand Tools Lighting / Flashlights Measurement Tools Paint / Body / Trim Tools Portable Power / Chargers Power Tools Shop Equip / Tire / Lube Shop Supplies / Safety Specialty Remember that the parts guy at Autozone, is not really doing any testing, he's just scanning codes. If you see black residue on the ground after this, that is carbon.

Sorry I'm not more help. How much do they cost each. It can also be caused by low fuel pressure or a plugged injector." Share Share this post on Digg Del.icio.us Technorati Twitter 12-26-2008, 02:31 PM #3 focusmaniaczx3 Hope this gives you some answers.

Anmelden 19 21 Dieses Video gefällt dir nicht? you can easily check for a blocked CAT and resultant low engine vacuum by taking an engine vacuum measurement with a vacuum gauge.I would suggest NOT buying ANY parts until you Cat Tester Tool Aid 33600. And while that's a good free service, it will only take you so far in determining what's wrong.

There is an article that talks about your PCV valve & hose repair. If your codes reappear, I would look for other causes like a vacuum leak or a problem with the fuel pressure or injectors. If the Apten chip was the problem, it seems like you would probably have additional, unrelated codes as well, but I'm really guessing at this point. Buy the way, O2s cost about 50 bucks at AZ.

A week later the code comes back so I toss in two new O2 sensors. Ask Your Own Ford Question Share this conversation Related Ford Questions Question Date Submitted F150: Hello, I have a Ford F150 2001 V6 with 172,000 miles, 3/4/2013 3/4/2013 fordanswer4u volvo XC90 Zenpal. Aftermarket Products Air Intakes, Air Filters & Ram Air Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics Ford In-Vehicle Tech

I have not yet contacted Apten, since it seems to me when I ran it with JUST the Apten every thing it did, made sence. If not, then add the Apten chip, and wait, see what happens, if no code then add the MAF and see if THAT creates the code. Top jts motorsports Posts: 4 Joined: Mon Apr 30, 2012 10:38 am Re: P1131 code Quote Postby jts motorsports » Sat May 19, 2012 7:26 am Thanks for the infoJeff Top Recent Posts Before buying a used Dodge or Jeep with a 3.7 or 4.7 Engine How to replace a floor jack's U-Joint pn 248731 Kent Moore J-42385-507 Inserts in STOCK!

Join Date: Apr 2008 Fan#: 55157 Location: conover, NC What I Drive: zx3 turbo, kia soul, 71 chevy c/10 Posts: 6,099 Points 16,300, Level 81 Level Up 90% Completed Forum Activity It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Searches ExplorerForum.com Page 1 of 2 1 2 Next > MONMIX I fix dents Staff Member Moderator Elite Explorer Joined: April 16, 2002 Messages: 9,086 Likes Received: 4 Trophy Points: 58 I'm having a hard time finding it.

The 1-6 in the powertrain codes, indicate which cylinder. I'm pretty sure it's the same sensor replaced each time. But I wouldn't replace any any O2 sensors until you confirm there's no mechanical issues the and the misfire problem is fixed. http://www.explorerforum.com/forums/showthread.php?t=63466&page=1&pp=20&highlight=granatelli+maf Al Franklin My truck My Quest for 30 RIP Al Franklin! 1947-2010.

A check of the EGR (exhaust gas recirculation) valve should be done to determine if it's clogged or stuck open. One other thought is that the aftermarket air intake and/or MAS has a leak somewhere that is allowing unmetered air into the system. Melde dich bei YouTube an, damit dein Feedback gezählt wird. I did that for a week prior to the instal of the chip with out an issue.

NateE : Date: November 26, 2014 @ 8:12 pm Hi Dennis. Take care. Bitte versuche es später erneut. When I bought the truck, the muffler was clean of carbon.

So, DogFriend, if you were to guess, MAS or Apten ? For the idle issue, I would also clean the throttle plates and check the IAC (Idle Air Control) motor. The codes have always been 02 based. Question – I’ve scanned a P1131 in my VW, does this have the same code definition?

And let's see what gives. Broke a 3/16″ Drill Bit - What to use Car Tools & More Auto Tool/Repair Blog Northstar Studs?Car Heater Broken?Protecting Air ToolsA/C TroubleshootingFord Thread RepairBroken Spark PlugsLaser Alignment   . The Oxygen sensors normally switch from lean to rich continuously based on the Oxygen content in the exhaust. Good Luck.

Hope this helps. I was thinking it was a vacuum leak due to the high rpm at idle and sputtering like it was trying to die. martinjose View Public Profile View Gallery Find all posts by martinjose #3 09-13-2003, 01:56 AM zenpal New User Join Date: Sep 2003 Posts: 15 Error Code P1131 martinjose, Remember that the engine computer uses the MAF to enter calibrated values into the metering of fuel (pulse width at the injector).

Schließen Ja, ich möchte sie behalten Rückgängig machen Schließen Dieses Video ist nicht verfügbar. Now im told its my sensors. looked on various parts sites to get an idea but got confusing prices. Quote Postby autojoe » Sat Mar 01, 2014 8:10 am HO2S 11 is not switching, sensor indicates lean (O2 1 Bank #1).Check the O2 signal with the engine idling, the signal

Hope this helps. I really can't make heads or tails of what they are trying to tell me.Click to expand... I miss the chip. let me see if i can find the thread i had one it.

I changed the fuel filter out next which was dirty and put fuel system cleaner (Gumont stuff). Share Share this post on Digg Del.icio.us Technorati Twitter 12-26-2008, 07:58 PM #8 penguin Focus Fanatic Join Date: Apr 2005 Fan#: 21700 Location: Iowa What I