ex zr100 lens error Central Valley New York

Address 127 Upper Lakeview Ave, Ringwood, NJ 07456
Phone (973) 869-4005
Website Link
Hours

ex zr100 lens error Central Valley, New York

I had the same problem as holistic when trying to get the lens unstuck...the lens went back in after tapping the USB pad, but then the picture was all white on I couldn't wait to send off this POSITIVELY first comment ever. Sometimes even machines need a little shake. =) April 11, 2008 at 3:47 PM Anonymous said... holistic, Well good for you!

Please also comment if none of the fixes were successful, or if you tried something different that worked. I would appreciate your help, thanks! You can only upload files of type PNG, JPG, or JPEG. I have a Canon PowerShot SD200 which had the e18 error.

Should I apply "White Balance" settings in my camera? I didn't think it would. I'm sure you saved me a considerable amount in repairs or in a new purchase. Some of the later steps do involve some risk to the camera, so carefully weigh your options before deciding to conduct them: http://camerarepair.blogspot.com/2007/12...

Eventually i slowly applied pressure on the focas len, and the zoom mechinism, when it was switching off, and it make a click. May 28, 2008 at 1:06 PM Camera Repair said... I suspect a ribbon cable became dislodged or slightly disconnected from its connector. I have to say though, please add a caution to be gentle while doing the suggested tapping part.

When i turn it on everything is fine, i can zoom, look at my pictures and everything. Thanks in advance! Don't show me this message again. Who knows, you might get lucky.

Then I read your posting. 10 minutes very gentle force with a set of plumbing pliers (!) to straighten the crooked zoom and a reboot with new batteries got it running I found your website and removing the batteries and memory card worked for me. Add a comment Add a comment Add Comment 1024 Step 10 Edit The lens is held in place by two metal tabs: one located directly under the circuit board between the As for charging, I use a standalone charger too.

April 29, 2008 at 10:03 PM Anonymous said... Thanks a lot! December 28, 2007 at 8:55 AM Holistic said... Sonny DSC-W55:lens gets stuck occasionally on start-up.

Melde dich bei YouTube an, damit dein Feedback gezählt wird. Track this discussion and email me when there are updates If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and My camera was filled with sand...somehow, and the lens had got stuck and wouldn't retract. Usually it's sand or grit interfering with the lens extension mechanism.

This has to be THE most common failure mode for a digital camera, a stuck lens, jammed lens, or a malfunctioning lens. I tried pulling the lens to keep if from going back in, but that did not work. Sprache: Deutsch Herkunft der Inhalte: Deutschland Eingeschränkter Modus: Aus Verlauf Hilfe Wird geladen... Or the camera's been dropped with the lens extended.

May 8, 2008 at 6:45 PM loca lynn said... View the answer I have this problem too Subscribed to new answers Is this a good question? Recommend closely looking at the lens barrel when it's extended. Jay, thanks but its not necessary.

Folder cannot be created. this sucks i want all the picture on my camrea and all these way to fiz seem so legit... It might just be i really messed up my camera but i tried ALLL of the ways and nothing worked... I love my digital camera and I have to use it.But there's no way I'm sending it somewhere to get fixed and I don't want to have to buy a new

Dislodging Particles from Lens Barrel Gaps (Fix #5a) Fix #6: Repeatedly tap the padded/rubber usb cover on a hard surface with the intent of dislodging any particles that may be jamming It's easier IMO, so I can't speak to downloading from the camera itself. While doing these, listen for a click that indicates that the lens barrel guide pins have reseated in their guide slots. the camera will not turn on to take pictures, but it will let you view the pictures you have already taken.first of all, there is nothing wrong with your memory card.

Particularly I do not recommend probing deeply around the most outer (largest) lens barrel gap, as you may dislodge the lens barrel dust gasket that's located just inside of that gap. When I hit the power button, I noticed that the telescoping lens tried to adjust itself but got crooked. Finally, I'm curious just how many people actually read this far down into this article.