event 11 the driver detected a controller error on Branchport New York

Computer Repair, Training & Consulting, Purchasing Assistance, Web Banner Design Available worldwide by on demand remote connection to your Internet-enabled computer using the best Secure Remote technology! Competitive rates. Hours by appointment only: Mon-Fri: 5:00 PM-9:00 PM, Sat-Sun: 9:00 AM-5:00 PM. Payment on www.YourPCandMacHelper.com with Charge Card/Credit Card/PayPal. Call: 585-317-364

Address Geneva, NY 14456
Phone (585) 317-3641
Website Link http://www.yourpcandmachelper.com
Hours

event 11 the driver detected a controller error on Branchport, New York

Boot-up returned to normal speed and errors went away after disconnecting the card reader. One of them I was able to find the cause by simply installing Dell OpenManager Server Administrator and taking a look at the storage.The firmware driver was out of date. But this is just an assumption. Start - type regedit - enter.

Archives Archives Select Month October 2015 (1) August 2015 (1) March 2015 (1) November 2014 (1) March 2013 (1) December 2012 (1) September 2012 (1) May 2012 (1) March 2012 (1) I am just worried about losing data. Forum atapi Event ID 11 Please Help Forum Crash to black screen, Critical Kernel-power error, Event ID 41, Task Category 63 Forum Solvedevent viewer WHEA error "event id 19" "Processor ID: I was able to pick up 8 GB of Gamer grade memory for $25 (after rebate), so that is another bonus with upgrade.

As an aside – DDR3 memory is Ridiculously Cheap. for a long time. Um no. It shows System Volume Information and BESR's directories are being viewed. 0 LVL 46 Overall: Level 46 Storage Hardware 30 Windows 7 16 Hardware 11 Message Active today Expert

I am watching it carefully and will replace it if it happens one more time. might be finally solving it. However, we occasioanlly get the following error in the system log "The driver detected a controller error on \Device\Harddisk1\DR5." It's USUALLY when the drive is first plugged in for the day, The rest of the time, we just get this error by itself.

It didn't get us very far though. Please folow below link.. You can use Disk Management to view this information without using Registry Editor. Have done all the usual troubleshooting as you would expect.

And sure the event log was giving various errors. 0 LVL 46 Overall: Level 46 Storage Hardware 30 Windows 7 16 Hardware 11 Message Active today Expert Comment by:noxcho2010-07-01 The Cause for concern? Is it lossless? The Properties will contain "Device Type" information that will tell you if the disk is IDE or SCSI, and it will also display the "Hardware Vendor" name of the physical device

We can check that this evening. 0 Message Author Comment by:Jsmply2010-07-01 Going to go now and do the swap on-site so we can get a first hand answer. At first, I was pretty much convinced that HD is dying. I will check the registry this evening when the machine is not in use. Does that mean the one mentioned in the EVENT was just actually my flash drive?

Worth the time and effort? Well, if it were kicked to a tier 3 engineer they might be curious but honestly when they're up to their necks in crocodiles do they have time for my frog Nothing in the application log. 0 LVL 46 Overall: Level 46 Storage Hardware 30 Windows 7 16 Hardware 11 Message Active today Expert Comment by:noxcho2010-07-01 Does it remove the drive Next step was to run diagnostic from manufacturer (WD in this case), which reported SMART info was good but there are some bad sectors.

It tests for very many things, so also worth a try to see what it says for you. So the disk numbers shown in the Disk Management console (Disk 1, Disk 2, Disk 3, etc) correspond to the \Device\Harddisk# in those Event Log errors. After lots of drive and cable swapping I have discovered it happens because I have the drive caddy plugged into a Noontec USB3 hub. Ocanada any idea where to check what you suggested in Windows 7?

And it also not good to change hard disk to different port, where controller manufacturer is different. (btw I once did that, changed it from Marvell, to normal ICH9 SATA controller, IE: \Device\HardDisk1\DR5, then the error can be shown with \Device\HardDisk1\DR1, and then \Device\HardDisk1\DR2, etc. but I have yet to find a decisive way to figure out which physical drive is which given the information \Device\Harddisk2\DR2. When I bypass the hub and go straight to the PC it does not happen.

I use DISKPART: CMD > DISKPART list disk 0 Pimiento OP slacka Feb 3, 2014 at 5:57 UTC 1st Post I just read all of the answers, even Wednesday, July 01, 2009 7:06 PM 0 Sign in to vote hi there, these DR's represent different meaning while writing device drivers, which i think it is of no use when I'll try to disable this function for a few days, and let you know what happens... An example of English, please!

Our software tests controller, seek, and surface.

Dec 21, 2011 The driver detected a controller error on \Device\Harddisk4\DR4.

Feb 14, 2012 message string data: \Device\Harddisk6\DR6

Feb 21, 2012 The driver detected My System Specs OS Microsoft Windows 7 Home Premium 64-bit 7600 Multiprocessor Free CPU Intel(R) Core(TM) i3 CPU 530 @ 2.93GHz Motherboard Acer FIH57 Memory 3.00 GB Graphics Card Intel(R) HD I did install ubuntu and it does run better but instead of hanging for 10-20 seconds it just locks up when I try to do too much at once or randomly what's happening is the harddisk is being turnoffed and not being turned back on.

Since then I have traced the problem to the HD caddies I had my drives in, which until last week worked fine. USB) drives. Did you know you can avoid “tarnishing” your license in such scenario by Skipping product key page during Windows 7 setup? It would seem that on many of the motherboards out there windows 2000 does not support different drive types.

However, no backups are running at this time. like C:, D:, etc and which is the harddrives and dvd/cd, floppy, etc. OS seems to silently recover from this problem 10 to 60 seconds later, which is really strange in my book – considering that user isn’t even alerted to this serious atapi Feel free to leave comments if you are still struggling with this issue, and I will try to answer.

no it's a wall! Hope this helps. We have backup image failures on the drive that gives error If I understand correctly... My System Specs System Manufacturer/Model Number HP Pavilion e9110t OS Windows 7 Home Premium 64 Bit CPU Intel(R) Core(TM)2 Quad CPU Q9550 @ 2.83GHz Motherboard Pegatron IPIEL-LA3 Memory 6.00 GB Hundai

Thanks for any helpful reply... And, it seems to occasionally just occur throughout the day for no reason.