freenas smart error Shady Dale Georgia

Address 10921 Highway 36 Lot 33, Covington, GA 30014
Phone (678) 570-5652
Website Link
Hours

freenas smart error Shady Dale, Georgia

After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 59 18 e8 ef 54 e0 Error: UNC 24 sectors For example, the following cases will all produce errors that do not indicate potential device failure: A network attached device lost connectivity but has now recovered A device suffered from a On the second link the examples on how to use it will be the FreeBSD ones since under the hood FreeNAS is FreeBSD bundled with a few other things. I waited and during the next 2 minute check I got an email that the self test failed.

How I recovered see below in the answer. I was using 9.1, but I am currently using 9.1.1. #8 Updated by Dusan Lacko about 3 years ago Now we are getting somewhere. You won't be able to vote or comment. 000Getting an error. Note: a short test will take a minute, a long test will take around 4 hours.

Upon bootup with no -a parameter I receive an email that CUPS and OUNC were non-zero. Conveyance self-test routine recommended polling time: ( 5) minutes. I had the exact same problem. Where are sudo's insults stored?

Then I updated the board BIOS (recommended according to instructions). I purchased these drives from Newegg in March of 2014. I'll report back then. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 59 18 e8 ef 54 e0 Error: UNC 24 sectors

Tried to register AuthRecord 0000000800C2FD60 s-FreeNAS.local. (Addr) that's already in the list ... You can force a scrub again with zpool scrub pool_name and you should be good. Home Categories FAQ/Guidelines Terms of Service Privacy Policy Powered by Discourse, best viewed with JavaScript enabled current community blog chat Server Fault Meta Server Fault your communities Sign up or log Thus I'm not sure where to get startet with error analysis and how to solve them.

Auto Offline Data Collection: Disabled. See the avaton family, supports a total of 6 sata ports ark.intel.com/products/77982/Intel-Atom-Processor-C2550-2M-Cache-2_40-GHz Another thread about the issue https://forums.freenas.org/index.php?threads/asrock-C2750D4I-vs-x10sl7-f-sata-ports.30847/ See info below www.tomshardware.com/forum/308172-30-sata-controller-question#4425211 Asus P8B-X | Pentium G2020 | 24GB RAIDZ2: So clearly the mini was tested using the Marvell controller, and it passed. After scrubbing, everything was 100% healthy.

However reading carefully you should be able to recover your zfs raid yourself! The system is connected to an onboard Intel SATA controller that properly passes through SMART commands. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was Then waited some seconds before realizing it was wrong and trying to stop it with control-C which seemed nonresponsive.

Thanks for posting this. Of course, replace /dev/ada0 with your drive identifier. SCT Feature Control supported. DaveY, Aug 1, 2016 #20 (You must log in or sign up to reply here.) Show Ignored Content Page 1 of 2 1 2 Next > Share This Page Tweet Log

General Purpose Logging supported. I was able to detect the problem with zpool status: zpool status myzfs pool myzfs state: DEGRADED (DESTROYED) The good news. I used bootable USB keys for the board and controllers. May they be the reason for the problems.

General Purpose Logging supported. Truth in numbers Why is the spacesuit design so strange in Sunshine? After it finishes, check test results: smartctl -a /dev/ada2 The output will tell you two important things. In information section there is sector size: Sector Size:      512 bytes logical/physical Near Error 3 occurred at disk power-on lifetime: 27422 hours (1142 days + 14 hours) When the command that caused the error occurred, the device was in an unknown state.

I am sure this thread will be helpful to several people. I really wish I had read the comments first before trying this… Reply noobfix permalink In reply to "Oooof" lol, One would think Freenas whould have a simple web ui point SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was fta, Jul 23, 2015 #12 DrKK FreeNAS Generalissimo Joined: Oct 15, 2013 Messages: 2,606 Thanks Received: 582 Trophy Points: 111 Occupation: Promulgator of Peace and Love Location: East Coast USA fta

For me it worked. mrgodwin 2015-07-14 00:50:48 UTC #2 Bump :/ darkhorseman91 2015-07-14 00:55:45 UTC #3 What OS is the the NAS running? Definitely do all three tests on any replacement drives you wind up getting. Click hereThis article has no commentsShow me similar articles [ HOME | TOPICS | INDEX | WEB RESOURCES | BOOKS | CONTRIBUTE | SEARCH | FEEDBACK | FAQ | FORUMS ]

Page 1 of 2 1 2 Next > Murac Newbie Joined: Mar 18, 2015 Messages: 30 Thanks Received: 4 Trophy Points: 6 So this is my first post to this fine If Selective self-test is pending on power-up, resume after 0 minute delay. The harddrives do show smart errors. I'm not sure what to do next.

How should I interpret "English is poor" review when I used a language check service before submission? He has the same Marvell controller as the FreeNAS mini. I can confirm that I definitely get emails(technically I get text messages to my phone) when I hit my temperature threshold (37C), as well as Current Pending Sector Count being non-zero(which Total time to complete Offline data collection: (13800) seconds.

permalinkembedsavegive gold[–]-RYknow[S] 0 points1 point2 points 1 year ago(2 children)Thanks for the input. Browse other questions tagged freebsd hard-drive zfs freenas smartctl or ask your own question. Nagios is reporting: Raid Critical!. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode.

Since installing the update and rebooting the machine, the smart error has gone away. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: FAILED! But I've been doing a lot of blogging at dan.langille.org because I prefer WordPress now. This caused ZFS to take it completely offline and put my pool in a DEGRADED state.

Updated over 2 years ago.