frigidaire gallery stove f10 error Silver Plume Colorado

Address 155 Snowberry Way, Dillon, CO 80435
Phone (970) 262-9181
Website Link
Hours

frigidaire gallery stove f10 error Silver Plume, Colorado

Especially since the EOC had failed once before on warranty (it completely burned out and wouldn't work at all) and the repair tech told me that self clean was likely to The EOC part number 316207529 Happy New year! As soon as I turn on the oven it started flashing the F30 error. The content in this area cannot be displayed because your browser has JavaScript disabled (or does not support it, not common).

The EOC part number 316455400 Thank you for your question. Mike Gene // Jun 6, 2015 at 10:30 pm Hello Mike, Thank you for your question. You may want to call AppliancePartsPros.com customer service at 1-877-477-7278 to find out the ETA. Check the lock motor and the switches for continuity.

The part number for the oven relay board is 316443920 The part number for the EOC is 316576601 Good luck. Good luck. Gene. Wiedergabeliste Warteschlange __count__/__total__ Range Error Code F10: Troubleshooting Runaway Oven Temperature Sears PartsDirect AbonnierenAbonniertAbo beenden11.34611 Tsd.

It is located behind the control panel. It appears I do have a separate power/relay board, EOC board and a power supply board. It is self-adhesive. Just call their customer service.

Jake Can you see the probe from inside the oven, I see a probe of some sort right above the oven light, is that it? Our oven flashed F10 and went into runaway temps. I checked the RTD temperature probe at the plastic connector (1083 - 1100 ohms). I bought laser thermometer for the oven and it would verify the lower temperature.

We have had another electrical issue with our range CEW30EF6GSC. Set your multi-meter to read ohms and put one meter lead on each wire terminal of the temperature sensor. Enjoyed reading your help to other people. You can get it from AppliancePartsPros.com for $558.91.

Is it something that an amateur could easily do? Any suggestion is highly appreciated. Gene. Gene.

Thanks, Ehsan. If the temperature sensor checks okay, remove the top, back panel then plug the harness back in to the sensor and unplug the other end from the control board. Well, it was almost a year to the date. Gene // Jul 9, 2015 at 2:26 pm Hello, Bessie.

You may want to replace it as well. F95 Door motor mechanism failure. Any help would be greatly appreciated. Valerie // Apr 24, 2015 at 7:00 am Hi Gene, I am having problems again and before I order on my diagnosis, I wanted your confirmation.

model #GLEF378ABC. Remove the power from the oven and pull the oven out of the cabinet. Any of these coils are not serviceable. At the same time make sure the wire harness from the probe to the control panel is not damaged.

Wird geladen... If the oven is overheating, disconnect power. In your case, I'll bet that it's either that, or your Resistance Temperature Detector needs to be replaced. Remove the power to the range by turning off the corresponding circuit breakers prior to do any job.

Can you please tell me, does this sound like a bad control board? Please check back in a few minutes. Resolved Question: How do I turn off the beeping sound when my Frigidaire oven says an F10 error code?Thank you Submitted: 5 years ago. Save model in your profile permanently Don't have a profile?