ford focus cd player error e3 Pine Colorado

Address 26076 Stansbery St, Conifer, CO 80433
Phone (303) 816-1383
Website Link http://freepcdiagnostic.com
Hours

ford focus cd player error e3 Pine, Colorado

TEST the system for normal operation. TEST the system for normal operation. CD Error Codes Vehicles with 6006E or 9006 Audio Unit Error Codes Error Code Error Description Error Rectification E1 Communications Error Install a new audio unit. C3: CHECK SPEAKER RETURN FOR SHORT TO GROUND

1 Measure the resistance between the affected speaker connector pin 2, harness side and ground.

If the wiring harness is OK, DISCONNECT the audio unit power connector, SWITCH the audio unit ON and OFF four times then CONNECT the audio unit power connector. Test speaker circuit. 6. If the error code is still displayed. TEST the system for normal operation.

Distorted sound from one or more speakers (not all speakers) * Speaker(s). * Circuit. * Audio unit. * GO to Pinpoint Test C. Yes GO to A2. REFER to: Antenna Cable - LHD (415-02 Antenna, Removal and Installation) / Antenna Cable - RHD (415-02 Antenna, Removal and Installation). Yes GO to H2.

No REPAIR circuit 91-MD15 (BK/GN) or 91-MD34 (BK/YE). The CD player does not operate correctly * Audio unit. * INSTALL a new audio unit. No REPAIR circuit 29-MD15 (OG/BK) or circuit 75-MD15 (YE/GN). Yes GO to E2.

Is the resistance approximately 4.0 ohms? TEST the system for normal operation. Is the resistance less than 1 ohm? PINPOINT TEST B : POOR RECEPTION TEST CONDITIONS DETAILS/RESULTS/ACTIONS B1: CHECK THE ANTENNA CABLE SHIELD 1 Ignition switch in position 0. 2 Ignition switch in position 0. 3 Disconnect Antenna Cable.

Visual Inspection Chart Mechanical Electrical Audio unit damage Cassette player jammed, not loading Compact disc (CD) player jammed, not loading Antenna/alignment Fuse(s) Circuit(s) Electrical connector(s) Audio unit Speakers Subwoofer amplifier If To navigate through the audio unit Self-Diagnostic Mode, depress the preset button 6. Yes INSTALL a new subwoofer amplifier. Test speaker circuit left hand front speaker. 4CH LF for four channel system 2CH LF for two channel system.

Are the resistances greater than 10,000 ohms (open circuit)? F2: TEST THE AUDIO UNIT TO CD CHANGER HARNESS 1 Disconnect CD changer C465. 2 Disconnect Radio Remote Control C437. 3 Disconnect Audio unit C464. 4 Carry out the CD changer If the concern persists, DISCONNECT the audio unit power connector. REFER to: Audio Unit (415-01 Audio Unit, Removal and Installation).

REFER to: Subwoofer Amplifier - 2.0L Duratec-ST (Zetec) (415-01 Audio Unit, Removal and Installation). E2: CHECK SPEAKER CIRCUIT RESISTANCE - SPEAKER DISCONNECTED 1 Disconnect Audio Unit C442 or C450.

2 Measure the resistance between the audio unit C442 and the speaker connector pins for WAIT 20 seconds and then CONNECT the audio unit power connector. To exit the Self-Diagnostic Mode do not press any button on the audio unit for 10 seconds.




4 Electrical > 415 Information and FM waveband check. No REPAIR the circuit in question. TEST the system for normal operation.

TEST the system for normal operation. Test speaker circuit right hand rear speaker. 4CH RR for four channel system. Is voltage present? FM frequency received.

No REPAIR the circuit in question. No REPAIR the circuit(s). If the concern persists, INSTALL a new audio unit. REFER to: Audio Unit (415-01 Audio Unit, Removal and Installation).

Yes CLEAN and TIGHTEN the ground connections at the base of the antenna, audio unit case and battery negative cable to the body. Visually inspect for obvious signs of mechanical or electrical damage. TEST the system for normal operation. TEST the system for normal operation.

If concern persists, INSTALL a new audio unit. If the error code is still displayed, INSTALL a new audio unit. Symptom Chart Symptom Possible Sources Action The audio unit is inoperative or does not operate correctly * Fuse(s). * Circuit. * Audio unit. * GO to Pinpoint Test A. CD Error Codes - vehicles with 6000 Audio Unit Error Codes Error Code Error Description Error Rectification E11 SPI Bus Failure CHECK and REPAIR the wiring harness.

TEST the system for normal operation. Yes INSTALL a new audio unit. Check the heater duct(s) are not bleeding hot air on to the radio. TEST the system for normal operation.

A2: CHECK THE AUDIO UNIT GROUND CIRCUITS FOR OPEN 1 Ignition switch in position 0.

2 Measure the resistance between the audio unit C443 or C446 pin 6, circuit 91-MD15 TEST the system for normal operation. The CD changer is inoperative or does not operate correctly * Fuse(s). * Circuit. * CD changer. * GO to Pinpoint Test F. REFER to: Subwoofer Amplifier - 2.0L Duratec-ST (Zetec) (415-01 Audio Unit, Removal and Installation).

C2: CHECK SPEAKER INPUT FOR SHORT TO GROUND 1 Disconnect Audio Unit C443.

2 Measure the resistance between the affected speaker connector pin 1, harness side and ground. Compact disc communications circuit. INSTALL a new CD changer harness. No REPAIR circuit 8-MD26.

Are the voltages greater than 10 volts? Is the audio unit to CD changer harness OK? If the error code is still displayed, INSTALL a new audio unit. REFER to: Audio Unit (415-01 Audio Unit, Removal and Installation).

TEST the system for normal operation. Does the audio unit operate correctly without using the remote control?